10-04-2011 11:19 AM - edited 07-03-2021 08:52 PM
I am having some dificulties on finding information on how to set up two Cisco 1252 autonomous access points, via the command line. I am not having any luck finding steps or suggestions on how to go about doing this and was curious if any one would be willing to give some insight.
I am working on taking two of them setting one up as the root bridge and the other as non-root.
Thank you in advanced
10-04-2011 11:20 AM
Are you trying to do a PtP ?
10-04-2011 11:27 AM
Yes, I plan to have the root wired in to the network and then bridged to another ap in a seperate building with a switch plugged into it giving access to other machines.
10-04-2011 11:47 AM
Check this link out ... I didn't find an official cisco examples that might help... But i think this will get you started.
https://supportforums.cisco.com/docs/DOC-16087
If you find this helpful please dont be afraid to rate post!
Thanks!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide