I'm trying to set up a DHCP Pool for a Cisco 1542i AP using the GUI. When I input the following information and press apply it just goes to a white screen and seemingly deletes all the info I just input. When I revisit the DHCP tab it's reset to the same values the device started with.
IP Address: 172.24.100.0
Subnet Mask: 255.255.255.0
Default-Gateway: 172.24.100.1
DHCP Server (Enable/Disable): Enable
DHCP Starting IP Address: 172.24.100.10
DHCP Ending IP Address: 172.24.100.250
DHCP Lease Time (Minutes): 1440
Am I incorrectly inputting the info or what? Any help would be fantastic, thank you.
