12-10-2014 10:42 PM - edited 07-05-2021 02:06 AM
Hi ,
A Simple query .
As you all know , the cisco 1700 access points come with two 1GE uplink ports .( Primary and Auxilliary ).
I was under the impression that i can connect both these ports to an uplink switch , to create a LAG.
Is it possible ? or is it strictly an Auxiliary port and can't be actively used at the same time ?
Solved! Go to Solution.
12-10-2014 10:48 PM
I was under the impression that i can connect both these ports to an uplink switch , to create a LAG.
For the time being, the Auxiliary port cannot be used as a LAG.
Future software release will support EtherChannel of the two ports.
12-10-2014 10:48 PM
I was under the impression that i can connect both these ports to an uplink switch , to create a LAG.
For the time being, the Auxiliary port cannot be used as a LAG.
Future software release will support EtherChannel of the two ports.
12-11-2014 09:54 AM
Thank you Leo !
12-11-2014 10:04 AM
There is another reason why this does not require aggregation.
1700 support 11ac wave 1 which is 1.3Gbps over the air data rate. Considering RF efficiency (~40-70% due to management & control overhead) real throughput is much less than 1Gbps. So 1Gbps physical port is not a limitation for 11ac wave 1.
HTH
Rasika
**** Pls rate all useful responses ***
12-11-2014 10:46 PM
Hi ,
Thanks for the reply.
But i guess we would be seeing >1G uplinks post WAVE-2.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide