Cisco 1941W - Wireless - 2 VLANs

[aravindhs]

Hello Experts

I'm writing to get some urgent help with Wireless on Cisco 1941W.

The requirement is to have two subnets/VLANs/BVIs on the router (one for corporate access and another for Guest-Internet access. Both are to have wired and wireless clients.

On the router,

BVI1/VLAN1 is Corporate Access - 10.20.31.254/25

BVI10/VLAN 10 is Guest Internet - 10.20.31.126/25

With G0.1 as a native dot1q vlan on the AP and 31.253/25 as bvi1, the AP pings .254 pings fine.

With G0.10 as a dot1q vlan 10 on the AP and 31.253/25 as bvi1, the AP pings .125 won't ping.

I'm unable to get it to work. Can you please help ?

Many thanks

Aravind

[Stephen Rodriguez]

Can you post the entire config?  Router and AP

[aravindhs]

Hello Sir,

Thank you for your reply. I read another thread about the 1941W wireless config and I think i may have sorted it out. The customer is yet to test it and get back to me but I think it should be pretty much ok. The platform specific thing that I did not know was the switchport mode trunk on the wlan-gig0/0 interface on the router. Apart from that the config seems to be straightforward. I will come back to you if it doesn't work.

Regards

aravind