CIsco 2702 AP Blinking Red/Green

[Jason Amick]

We just attempted to deploy several Air-AP2702i APs.  They seem to associate to the controller fine but are blinking red/green.  After research and reading the below link it looks like they were shipped with the universal/country code as UX.  From my understanding you have to download and use the Cisco provision app to prime the AP to US country code.  The problem is these APs are at a remote site and we do not have a tech local that would be able to troubleshoot this.  So my question, is there a way to prime the AP using the WLC or any other way to do it remotely?  Thanks!!

https://supportforums.cisco.com/discussion/12445481/cisco-2504-two-air-ap2702i-blinking-red-green-and-black

[Rasika Nayanajith · Accepted solution]

No way to do it remotely.

At least 1 AP you have to prime using the provisioning application & other AP nearby can use NDP & prime them self without any manual work. Refer below for guidelines of this conversion process

http://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-0/AP_Regulatory_Domain_DG/b_universal_AP_regulatory_domain_DG.html

HTH

Rasika

[mohanak · Accepted solution]

No remote priming, minimum 1 access point needs to be primed.

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/ux-ap/guide/uxap-mobapp-g.html#pgfId-77563

[Jason Amick]

Thank you both for your responses I assumed this was the case but wanted to be 100%.  Looks like I will be priming one here and then shipping it out to the remote site so the other can see and learn the country code via OTA/NDP.  Is this something we need to look for when we order the APs or will all the future cisco APs be shipped with the UX country code?