We have a 2802I AP that is showing as connected on the switchport. It was only pulling 15400 watts. I manually set the power consumption to 26000 watts and then restarted the port. I then reverted back to power inline auto and now it pulls the correct power.
Gi2/0/40 auto on 26.1 AIR-AP2802I-B-K9 4 30.0
Gi2/0/40 XXX-WH-AP10 connected trunk a-full a-1000 10/100/1000BaseTX
The radios on the AP will not come up. Admin is up, but operational is down. I am able to ping the device.
Any assistance/feedback would be appreciated.
