cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
670
Views
0
Helpful
2
Replies

cisco 3850 not register APs

Hello.

I have 3 3850 switches. One is used as MC, two are used as MA. With one of it I succesfully created tunnel, but the second one do not allow me to register points and do not start tunnel. Also on MC I get message:

*May 14 2014 06:47:11 EET: *%MM-3-CONFIGDOWNLOAD_FAILED: STANDBY:2 wcm:  Failed to send a config download response packet sending packet to 10.2.53.104.   (sw_wlc_stack-2)
*May 14 2014 06:47:11 EET: *%MM-6-PING_RECEIVER_ENTRY_DELETED: STANDBY:2 wcm:  Deleted ping receiver entry(10.2.53.104) from hearbeat list for WLAN(-1).   (sw_wlc_stack-2)
*May 14 2014 06:47:14 EET: *%MM-3-CONFIGDOWNLOAD_FAILED: 1 wcm:  Failed to send a config download response packet sending packet to 10.2.53.104.

On this MA:

sw_mc_11#sh wireless mobility summary

Mobility Agent Summary:

Mobility Role                                   : Mobility Agent
Mobility Protocol Port                          : 16666
Mobility Switch Peer Group Name                 :
Multicast IP Address                            : 0.0.0.0
DTLS Mode                                       : Enabled
Mobility Domain ID for 802.11r                  : 0xac34
Mobility Keepalive Interval                     : 10
Mobility Keepalive Count                        : 3
Mobility Control Message DSCP Value             : 0
Switch Peer Group Members Configured            : 0

Link Status is Control Link Status : Data Link Status

The status of Mobility Controller:

IP              Public IP            Link Status
------------------------------------------------
10.1.5.30       10.1.5.30            DOWN : DOWN                    

sw_mc_11#

Config on two MA are similar but only one works:

sw__serverna_mc_01#sh wireless mobility summary

Mobility Agent Summary:

Mobility Role                                   : Mobility Agent
Mobility Protocol Port                          : 16666
Mobility Switch Peer Group Name                 : PortCity
Multicast IP Address                            : 0.0.0.0
DTLS Mode                                       : Enabled
Mobility Domain ID for 802.11r                  : 0xac34
Mobility Keepalive Interval                     : 10
Mobility Keepalive Count                        : 3
Mobility Control Message DSCP Value             : 48
Switch Peer Group Members Configured            : 2

Link Status is Control Link Status : Data Link Status

The status of Mobility Controller:

IP              Public IP            Link Status
------------------------------------------------
10.1.5.30       10.1.5.30            UP   : UP                      

Switch Peer Group members:

IP              Public IP            Data Link Status
-----------------------------------------------------
10.2.53.100     10.2.53.100          UP                             
10.2.53.104     10.2.53.104          DOWN                           

sw__serverna_mc_01#

Could someone help me? And not-working MA does not register APs(((

 

2 Replies 2

ITNettverk HiBu
Level 1
Level 1

Hello.

 

I have the same problem.

Did you find a solution?
 

Can you explain your set up & post "show wireless mobility summary" output from your MC & MAs

HTH

Rasika

**** Pls rate all useful responses ****

Review Cisco Networking for a $25 gift card