cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1100
Views
0
Helpful
1
Replies

Cisco 5508 interface design problem

Cisco 5508 interface design

now i have connect wlc into infra same picture but ap can't register into wlc. How create interface for this diagram. please help me because access switch is unmanage switch i can't config trunk on this.i can install for this solution this isn't ?

thank you for best support.

samy

1 Reply 1

devils_advocate
Level 7
Level 7

Why are your AP's on different Vlans?

If you plan to create SSID's on different Vlans then you will need a trunk port to the WLC as the switch needs to pass tagged frames to it and the WLC needs to pass tagged frames back.

Out of interest, you are using a 5508 which is a fairly expensive piece of kit yet you are connecting it to an unmanaged switch. Why?

 

 

Review Cisco Networking for a $25 gift card