Cisco 892 Wireless issue

[aakashojha]

Hi team,

I have a strange error in Cisco CISCO892W-AGN-E-K9 that i bought for our clients a month back.

- the router doesn't display the SSID for a longer period. Its like on and off of the SSID, showing sometimes and sometimes blank.

Please help with the issue.

[Scott Fella]

Can you post the AP config. Is it different devices having issues or just one. They have within coverage.

Sent from Cisco Technical Support iPhone App

[aakashojha]

Hey Scott,

Please not the config below-

dot11 syslog

!

dot11 ssid NWEDC

   authentication open

   authentication key-management wpa version 2

   guest-mode

   wpa-psk ascii 7 1102161612020003162F2A

!

!

!

username nwedc privilege 15 secret 5 $1$.SrJ$u3EVvjrMbli/I6UODVJoW.

!

!

bridge irb

!

!

interface Dot11Radio0

no ip address

no ip route-cache

!

encryption mode ciphers tkip

!

ssid NWEDC

!

antenna gain 0

station-role root

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

bridge-group 1 spanning-disabled

!

interface Dot11Radio1

no ip address

no ip route-cache

shutdown

antenna gain 0

no dfs band block

channel dfs

station-role root

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

bridge-group 1 spanning-disabled

!

interface GigabitEthernet0

description the embedded AP GigabitEthernet 0 is an internal interface connecting AP with the host router

no ip address

no ip route-cache

bridge-group 1

no bridge-group 1 source-learning

bridge-group 1 spanning-disabled

!

interface BVI1

ip address 192.168.1.10 255.255.255.0

no ip route-cache

!

!

interface wlan-ap0

description Service module interface to manage the embedded AP

ip unnumbered Vlan1

arp timeout 0

[Scott Fella]

You need to either use WPA/TKIP or WPA2/AES. You have WPA2/TKIP and that is why. Try to change that and it should fix your issue.

Sent from Cisco Technical Support iPhone App

[aakashojha]

Thanks, i will try and let you know. But i do not understand what it has to do with the SSID

[aakashojha]

Hi Scott,

It does not work. I still have the same issue. SSID is ON and Off.

[fbarboza]

Hi, What is the code version the AP module is running?

[Sahil Mengi]

Hi,

Can you confirm the radio interface status when the issue is reported.

Do you see any r0.core/r1.core files in "sh flash"?

Regards

Sahil