cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
682
Views
15
Helpful
2
Replies

cisco 9800 wireless migration

naresh86
Level 1
Level 1

we are planning to migrate 5508 (8.10) wlc to 9800 as a part of DNA structure. physical appliances delivery were delayed. So virtual wlc is deployed. basic configuration was done

My question here is, can we use IRCM or mobility group to migrate all the data from 5508 to 9800(no configuration on it except mgmt ip address and Webgui access) without any additional configuration. Please let me know if its possible and also important notes to follow(if there is). 

1 Accepted Solution

Accepted Solutions

 "Can we use IRCM or mobility group to migrate all the data from 5508 to 9800? "

There is no way you to migrate configuration data from 5508 to 9800. You can use the below config converting tool to get equivalent CLI configs for your 9800. However, you should go supported configuration & apply it once you understand what those configurations will do.

https://cway.cisco.com/wlc-config-converter/ 

In general, you should not have client SVI on your 9800 (in AireOS you always need client SVI on 5508 - called dynamic interfaces). Also understand tags & profile concept in 9800, those are new concepts & no equivalent in 5508. Below post may help you to get high level overview

https://mrncciew.com/2022/06/30/9800-tags/ 

Once you get 9800 configured & AP registered, you should able to use config analyzer tool given above by Marcel to validate your 9800 configuration agains Cisco best practices

HTH
Rasika
*** Pls rate all useful responses ***

 

View solution in original post

2 Replies 2

marce1000
VIP
VIP

 

                             - You can do IRCM between 5508 and 9800 (virtual wlc) : https://www.cisco.com/c/en/us/td/docs/wireless/compatibility/matrix/compatibility-matrix.html , Check Table 1 and look at column Cisco AireOS-IRCM Interoperability  , for the  9800 virtual wlc  you can always have a sanity check on its configuration with  the CLI command : show  tech wireless , have the output analyzed by  https://cway.cisco.com/tools/WirelessAnalyzer/  , please note do not use classical show tech-support (short version) , use the command denoted in green for Wireless Analyzer

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

 "Can we use IRCM or mobility group to migrate all the data from 5508 to 9800? "

There is no way you to migrate configuration data from 5508 to 9800. You can use the below config converting tool to get equivalent CLI configs for your 9800. However, you should go supported configuration & apply it once you understand what those configurations will do.

https://cway.cisco.com/wlc-config-converter/ 

In general, you should not have client SVI on your 9800 (in AireOS you always need client SVI on 5508 - called dynamic interfaces). Also understand tags & profile concept in 9800, those are new concepts & no equivalent in 5508. Below post may help you to get high level overview

https://mrncciew.com/2022/06/30/9800-tags/ 

Once you get 9800 configured & AP registered, you should able to use config analyzer tool given above by Marcel to validate your 9800 configuration agains Cisco best practices

HTH
Rasika
*** Pls rate all useful responses ***

 

Review Cisco Networking for a $25 gift card