cisco-9800 wlc

[Anjana A]

Hello Team,

I have two 9800 wlc running in HA-sso.

in the current set up around 800 access points are registered with the wlc.

Is there a way to update the High availability in all the access points at a single time.

because configuring individual access points takes longer time.

Ap---ha>> primary /secondary controller (hostname/ip configuration)

Regards,

Anjana

[Leo Laohoo]

ap name <NAME> controller primary <WLC 1> <WLC 1 IP ADDRESS>
ap name <NAME> controller secondary <WLC 2> <WLC 2 IP ADDRESS>

[Haydn Andrews]

As @Leo Laohoo says, CLI commands.
I have a excel sheet and drop the AP names into one collumn then it completes the command using concatenate commands

[Rich R]

Same here - I use a spreadsheet.
There's also a new feature called AP Priming Profile which you can use to configure them with regex same as AP filters starting from 17.9.2
https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-9/config-guide/b_wl_17_9_cg/m_ap_fb_wlcs.html
Take note of the restrictions though.