Cisco Aironet AP 2700 Series (Autonomuos Mode / Standalone Configuration)

[amh4y0001]

Hi,

I am trying to configure an AP and following this video:

https://www.youtube.com/watch?v=5RE55VBsyDE

If I do exactly what is mentioned in this video, I am able to configure AP. On some client Machines AP is available while other can not find that newly created SSID (even I have selected broadcast).

1. Why is like some Machines can not reach / find the new SSID (all machine are near by each other).

2. How to deal with frequencies or range or is it something will be corrected automatically by AP?

3. How to make internet Connection with AP?

4. Currently I have an Asus wireless router, shall I plugin a Cable from that wireless router and connect AP?

[George Stefanick]

What radio (frequency) did you configure on the ap and on the client. post your config of the ap.

[amh4y0001]

Currently I have enabled Radio1-802.11AC 5Ghz

Are we not supposed to enable the Gigabit Ethernet Connections?

[Sandeep Choudhary]

Yes enable the gig0 port on AP and also enable the 2.4Ghz radio and then give a try again.

Regards

[amh4y0001]

Since I have 2.4 Ghz disabled, is this the reason some devices can not find the SSID?

[Sandeep Choudhary · Accepted solution]

May be :)

As I told in other posts that few client may support only 2.4 Ghz!!!

Regards

Don't forget to rate helpful posts