Cisco AP 1242AG not broadcasting SSID

[muhammad_2013331]

I have an AP in VLAN 6(t/w clinets) and VLAN 5 (t/w controller)..AP is joined to the controller, and all interfaces for VLAN6 created....but still can't see the SSID?

[Seb Rupik]

Hi there,

Look under: WLANs -> WLANs -> <wlan_id>

Under the 'General' tab for your WLAN is the 'broadcast SSID' checkbox ticked?

cheers,

Seb.

[muhammad_2013331]

@seb

Yes it is checked.

[Seb Rupik]

Just to confirm, is the AP in the AP Group 'default-group'?

WLANs -> AP Groups -> 'default-group' -> 'APs' tab

If it is in another AP Group, does that group list your SSID under its 'WLANs' tab?

[muhammad_2013331]

yes AP is listed in default-group...

[muhammad_2013331]

Can anyone please guide me through this process?

This is another show command on the Ap showing all Radio interfaces unset:

AP001b.d5f1.9900#sh ip int br
Interface IP-Address OK? Method Status Protocol
BVI1 10.10.6.1 YES DHCP up up
Dot11Radio0 unassigned NO unset up up
Dot11Radio1 unassigned NO unset administratively down down
FastEthernet0 unassigned NO unset up up

[Zain Khan]

Hi,

Broadcast the SSID in the AP group from AP group in WLANs tab

[muhammad_2013331]

I have done these steps....am using the default-group for AP's...is it possible that due to using the command to ignore certificate on vWLC, AP gets joined but do not work?

[Zain Khan]

---

@muhammad_2013331 wrote:

I have done these steps....am using the default-group for AP's...is it possible that due to using the command to ignore certificate on vWLC, AP gets joined but do not work?

---

what is the actual problem please elaborate i couldn't get?

Your APs not joining to WLC bcz of certificate?

[muhammad_2013331 · Accepted solution]

Problem was with vWLC you should use FlexConnect mode....with FlexConnect SSID is broadcasted, but never with Local AP mode...

@Zain Khan my AP is joined with the controller....

[khaldi.tasbih]

hello 

i think there are alredy APs running using the same brodcast channel make an interference