08-14-2012 09:00 AM - edited 07-03-2021 10:31 PM
Hello,
Ok so i tried to but a new image on my AP and putty closed about half way through the installation. now the configuration is messed up. I was wondering is there is anyway to set it back to its factory default settings? I can get into the AP through serial connection but cannot tellnet to it. It does pick up a ip address from DHCP.
Thanks,
08-14-2012 03:45 PM
This is the fastest and most effective way ... Using a TFTP Server to Return to a Previous Release.
08-15-2012 09:45 AM
Hi ,
If the unit is picking up an IP address then you should be able to ping the unit and access it via GUI or CLI.
If it does not work then use the console port to check the configuration and fix the issues.
Also you could use the mode button procedure to reset the AP to defaults.
What was the code the AP used to have and to what exact file name you upgrade the AP to.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide