cisco ap350 problem (only 50mw)

[fengjy2005]

i have a strange problem here...

i live in a etsi regulated country and purchased a cisco's air-pcm350 series

100mw (configurable,internal antenna) air-pcm352 pcmcia adapter,no problem

wheter its working in 100mw or 50mw.this is ok

i have also cisco's air-ap350 access point(ver:c350-k9w7-mx.122-15.JA) i opened it and took the

air-lmc350 pcmcia adapter out the problem is lmc350 is working in 50mw mode

max,it exactly the same pcmcia factor with pcm350 which can operate in

100mw. how can i raise the lmc-350 adapter to 100mw i tried everything with

firmware issues but got no answer.

and note that the 100mw pcmcia pcm-350 (internal ant) made in taiwan, 50mw

pcmcia lmc350 (have two mmcx connectors no internal antenna) made in

singapore.

Anyone knows how to raise the lmc350 pcmcia to 100mw?

thx

[ebreniz]

On the Power screen, read the screen information, click the Transmit Power up and down arrows, and select the desired client adapter transmit power level. To help minimize cell overlaps, you should strive to use the lowest power setting that supports full coverage of your wireless cell. Click Next to continue to the Security screen.

The maximum level programmed into the client adapter and allowed by your country's regulatory agency

http://www.cisco.com/en/US/products/hw/wireless/ps4555/products_installation_and_configuration_guide_book09186a0080150985.html