Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

We're planning on installing a wireless network using Cisco Aironet 1130AG series radios. Does anyone know if these wireless APs are upgradable to the 802.11n standard later on?

Hi all.I have a Cisco 1232 AP at a remote location. It was configured by somebody no longer with the company and I have no passwords for it, no do I have a back up config.It is using local authenticaiton.Is there a way to do a password recovery witho...

swoodyard by Visitor
  • 3161 Views
  • 5 replies
  • 0 Helpful votes

Just received the 7921, and wondering how to unlock the settings.. ?The manual just says: contact your system administrator... ohh gee - I?m the SA...RegardsSteffen

I have been working with IOS based autonomous APs for a some time now. However, need to have following questions clarified regarding Lightweight models. I have few of these APsa. AIR-AP1242AG-E-K9 (IOS ver. 12.3(8)b. AIR-LAP1242AG-P-K9 (IOS ver. 12.3...

magurwara by Level 4
  • 1003 Views
  • 1 replies
  • 0 Helpful votes

I know this has been talked about many times on this forum, but as I am upgrading my WiSM's and WCS server, I seem to be getting more of these minor alarms everyday. The alarm looks like this:AP 'MB:3:17', interface '802.11b/g' on Controller '10.60.1...

da.beaver by Level 3
  • 1073 Views
  • 2 replies
  • 0 Helpful votes

HiI'm designing a relatively large wireless deployment and it has been sized for approx 4K users.The network is to be layer3 with the intent of using AP groups to reduce the size of the broadcast domain.Are these assumptions then correct:1. During th...

Hi,Can anyone tell me if it would be legal for me to use a 9.5dbi sector 5ghz antennae on a 1510 AP in the UK.The part number im thinking of is AIR-ANT58G10SSA-N Many thanksShaun

In the process of rolling out a couple of 4402 controllers and went looking to make sure I had the latest image on them.I am a little confused about the version numbers to be honest.I am running 3.2.171.6The latest version appears to be 3.2.195.10 wh...

Hi all.I have a Cisco 1232 AP at a remote location. It was configured by somebody no longer with the company and I have no passwords for it, no do I have a back up config.It is using local authenticaiton.Is there a way to do a password recovery witho...

swoodyard by Visitor
  • 657 Views
  • 1 replies
  • 0 Helpful votes

Has anyone noticed an issue with Dell D620 Laptops using the Intel 3945 card and WinXP with regards to PEAP authenication (mschapv2)? We are migrating to a LWAPP enviroment, but current we have a large autonomous AP enviroment. We have a very mobile ...

BARRY GROSS by Community Member
  • 651 Views
  • 1 replies
  • 0 Helpful votes

1231g(12.3(7)JA4) and 7920 firmware ver3.0Authentication failed the WPA-PSK. please guide what's wrong the configuration.AP==dot11 ssid cisco vlan 10 authentication open authentication key-management wpa wpa-psk ascii ciscocisco!interface Dot11Radio0...

cjrchoi11 by Level 7
  • 1021 Views
  • 1 replies
  • 0 Helpful votes
Top Solution Authors
Review Cisco Networking for a $25 gift card