I'm trying to make a pre-auth ACL on the Cisco Mobility Express WLC (v8.8) for before users authenticate to my radius server and it just won't let me create the ACL. It's a guest WLAN with Captive Portal: Internal Splash Page with radius. For the life of me I can't get it to work.
I've tried creating the ACL in cli, which btw is the most horrendous experience ever. You can't define the ACL as you would on a switch, no you have to go thru a bunch of stupid commands that can either create a rule, modify it's source or destination, modify it's action. Take a look at this "marvel":
(Cisco Controller) >config acl rule ?
action Configure a rule's action.
add Add a new rule.
change Change a rule's index.
delete Delete a rule.
destination Configure a rule's destination IP address, netmask and port range.
direction Configure a rule's direction.
dscp Configure a rule's DSCP.
protocol Configure a rule's IP Protocol.
source Configure a rule's source IP address, netmask and port range.
swap Swap two rules' indices.
And after all this it still doesn't work.
Has anyone encountered this problem? Any ideea where I could find some answers?
