Hello,I need to filter Apple MacBook and alow it connect to corp SSID.My corp SSID have 802.1x auth with NPS server.Who can suggest me what to do?Filter the MAC address on the NPS? create new SSID and filter on the WLC?I have WLC 2504 BR,
I am going to upgrade FUS of a Cisco 2504.Currently it's information is as below: Manufacturer's Name.............................. Cisco Systems Inc.Product Name..................................... Cisco ControllerProduct Version......................
Hi Folks, In the past when working with WLCs the interfaces have always been configured as LAG / trunk with the dynamic interfaces/vlans all going through the same LAG.Can I have say some ports configured in a lag and then the left over physical por...
Hello everybody,I unfortunately have a Cisco Aironet Sytsme that I bought.Had I known that it is impossible to get firnware as a private person, I would not have bought the product. To the problem I have an AP 1702i that no longer starts. After the s...
Hello,we have moved internal vlan routing from core switch to cisco asa. Since the routing is moved I cannot access the web gui and ssh of our wireless controller 5508 over the management interface which is placed in another vlan where my client is.I...
Hi everyone,The last three new APs I have received from our supplier (official Cisco 1142 LAPs) have all successfully connected to our 4400 series WLCs but are all reporting as being in an Operational Status of 'Down' ie their A/B/G/N radios are not ...
Hello Experts, Will a AP in Mode: Monitor, Sub-Mode: wIPS be having any contribution to co channel interference?Will it be having any impact on channel utilization during containment?
I have a standalone system running "AP3G1-K9W8-M" with with Laptop connected (wired).I configured a static IP on the same subnet as the Laptop. I keep getting the error as seen in the title and the IP resets DHCP. How do get around this problem. Is t...
We are receiving bucketloads of messages similar to the below %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on GigabitEthernet2/0/40 (not half duplex) When I look at the AP it always shows as DC / Full Power rather than POE / Full Power. What e...
Hello everyoneThe Access Point C9120AXI-EWC can be converted to C9120AXI and vice versaembedded wireless controller Can it be migrated to a physical controller or to the cloud as it could be? If it were possible, would it have any cost?Thanks in adva...
I am going from a 100 license to a 250 license of the 5508 model. I have tftpd64 installed on my laptop and my laptop is configured with ip 192.168.1.2 while the controller is 192.168.1.1. My question is can someone guide me to the correct 'path" c...
I have a very old WLC (4402) that I inherited at a client site. One of the access-points that connects to this WLC had to be wiped and re-installed, and since it is not a LWAPP, I am a bit unsure as how to get this to connect to the WLC The AP requir...
Hello all, I am beginner in the world of wireless , and i need your help about the differents types of licences and how to deploy it on cisco wlc 5520 . DTLS , RTU and DNA smart licence. Best reagrdsAkram
