Cisco Prime Infrastructure 1.2.1 - Factory Reset gone?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-21-2013 07:14 AM - edited 07-03-2021 11:35 PM
Hi there,
does anybody now how to do an application reset/factory reset on Prime Infrastructure 1.2.1? It seems the previously known commands are not working anymore:
/admin# application reset-config NCS
This command is not supported in the current version of the application.
ncs db reinit is unfortuantely not enough. We tried to initiate the corresponding scripts from /opt/CSCOlumos/bin but not success so far.
VM deployment on XEN is very slow and i would like to avoid to wait 6 hours again for the large VAPPL to be ready.
Thanks a lot in advance
Cheers
Christian
- Labels:
-
Wireless Network Management
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-21-2013 12:47 PM
Yes it is gone.... So a new install is required.
Thanks,
Scott
Help out other by using the rating system and marking answered questions as "Answered"
*** Please rate helpful posts ***
