CISCO PRIME ports

[garyleggat]

Is there a command in Cisco Prime to see open ports

noticed in this 3.1 guide port 587 not listed

PortProtocolDirectionUsage

7	TCP/UDP	Server to endpoints	Endpoint discovery via ICMP
20, 21	TCP	Bidirectional server/devices	FTP transfer of files to and from devices
Server to Cisco.com	FTP download of files from Cisco.com
22	TCP	Server to endpoints	To initiate SSH connection to endpoints during troubleshooting processes
Client to server	To connect to the Prime Infrastructure server
23	TCP	Server to devices	Telnet communication with devices
25	TCP	Server to SMTP server	SMTP email routing
49	TCP/UDP	Server to TACACS server	Authenticate users using TACACS
53	TCP/UDP	Server to DNS server	DNS
69	UDP	Devices to server	TFTP
161	UDP	Server to devices	SNMP polling
162	TCP/UDP	Endpoints to server	SNMP Trap receiver port
443	TCP	Client to server	Browser access to Prime Infrastructure via HTTPS (enabled by default). This port is also used to check for software updates between the Prime Infrastructure server and cisco.com.
514	UDP	Devices to server	Syslog server
1099	TCP/UDP	AAA server to server	RMI registry
1522	TCP/UDP	Primary to secondary server, Secondary to primary server	To configure high availability database connection between the primary and secondary Prime Infrastructure
1645	UDP	Server to RAS	Authenticate Prime Infrastructure users via RADIUS Remote Access Server
1646	RAS to server
1812	Server to RAS
1813	RAS to server
4444	TCP	AAA server to server	RMI server
8082	TCP	Client to server	Health Monitor web interface, Apache/Tomcat JSP engine
8087	TCP	Client to server	Secondary server software update page
9991	UDP	Devices to server	NetFlow data receiver Note Used when the Plug and Play Gateway is integrated with the Prime Infrastructure server.
10022 to 10041	TCP	Devices to server	Range of ports used for passive FTP file transfers (controller backups, device configurations, report retrieval, and so on)
11011	TCP	Endpoints to server	Plain text dispatcher port for the Plug and Play Gateway Note Used when the Plug and Play Gateway is integrated with the Prime Infrastructure server.
11012	SSL dispatcher port for the Plug and Play Gateway
11013	Plain text plug and play port
11014	SSL port for the Plug and Play Gateway
61617	TCP	Server to endpoints	SSL port for Java Message Service connections Note Used by the Prime Infrastructure Plug And Play Gateway only.

Post navigation

[Haydn Andrews]

Believe from the CLI you can use the Linux commands 

netstat -lntu

[patoberli]

That's because there should be no need to open the port 587. That is typically a listening mail server, but Prime Infrastructure doesn't offer an incoming email service. In other words, you don't need to open this port.