Client Connected to WiFi Bridge Cannot Receive DHCP After Upgrade of AP1832i

[Ed Melendez]

I've had a small WiFi switch, set in bridge mode, connected to my network for a number years.  After I recently upgraded my 1832i APs to 8.8.111, no connected device can obtain an address via DHCP.  If I connect a device with a static address, the devices can pass traffic with no issues.

I have a few WLANs configured, and no issues with clients getting addresses from their respective VLANs.

Any ideas on how I can troubleshoot, or what setting(s) need to be enabled or disabled?

Thanks.

[Leo Laohoo]

Don't use 8.8.111.0 and upgrade to 8.8.120.0.

[Ed Melendez]

Took a little time, but I've upgraded to 8.8.120, but it's still not working.  Anything else I can try?

I'd prefer not to have to downgrade. I upgraded to 8.8.110 to resolve another issue.

Thanks.