Client does not roam across mutiple APs automatically when Signal is weak

[kelvin-yeo]

Hi Guys,

i have 2 APs

I realized that when a client associate with an AP1 (eg. one end of the room ), and walk towards the other AP2 (eg. another end of the room ), it does not roam across until I did a reset on my Cisco card.

The signal quality is less than 20% but still does not roam across even though my client is standing below the other AP.

Any advise if i can improve on this conditions.

Rdgs,

Kelvin

[ebreniz]

Use the mobile station configuration interface command.

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_command_reference_chapter09186a0080207efe.html#wp2593116