Client Isolation

MarkBrewster85862 · ‎09-15-2025

Client Isolation in MR56 AP's

aleabrahao · ‎09-15-2025

What is your question ❓

https://documentation.meraki.com/MR/Firewall_and_Traffic_Shaping/Wireless_Client_Isolation

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

MarkBrewster85862 · ‎09-17-2025

How do I implement it? Had a PEN Test - suggested I enable Client Isolation on the Guest WiFi. Will read over your reference.

Thanks.

aleabrahao · ‎09-17-2025

Take a look at this document.

https://documentation.meraki.com/MR/Firewall_and_Traffic_Shaping/Wireless_Client_Isolation

It's under Wireless > Configure > Firewall & traffic shaping

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

BlakeRichardson · ‎09-15-2025

Client isolation is a supported feature. Are you asking if it's possible or do you need help implementing it?

If you found this post helpful, please give it Kudos. If my answer solves your problem, please click Accept as Solution so others can benefit from it.

MarkBrewster85862 · ‎09-17-2025

Implementing. Couldn't find it in the SSID's.

Had a PEN Test and it was suggested that Client Isolation be enabled on the Guest SSID.