Command to save config on 1142 LAP?

[blarkins1]

I am trying to assign a static ip and default gateway to my LAP through the CLI, but after I reboot it, I lose the config and it reverts back to dhcp.

Is there any command to save the config to the AP through the CLI?  I've tried all I can think of (i.e. wr mem, copy run start, etc...) and have looked throught the available commands but cannot figure out a way to do it...

Thanks,

[Stephen Rodriguez]

yup, either a wr, wr mem should do it.  Unless the confreg has been changed for some reason.

When you boot in, do a dir flash: and you should see the config.txt

HTH,

Steve

----------------------------------------------------------------------------------------------------------

Please remember to rate helpful posts or to mark the question as answered so that it can be found later.