cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
582
Views
0
Helpful
1
Replies

WCS AP template application

Mirza Cutuk
Beginner
Beginner

Hi, i started getting this weird error message yesterday in WCS.

http://dl.dropbox.com/u/10913656/xda/Clipboard02.jpg

I have some generic and some per location templates.

Admin status on/off, hreap enable are generic.

Then i have templates for every location, as they are on separate vlans.

Hreap template applies fine, then the AP reboots.

When i try to apply template with native and switched vlans, thats when i get the error.

Unfortunately i am qute fresh with cisco wireless, and i have difficulities finding an answer on this topic.

Recently i upgraded WCS to 7.0.220. But i have deployed like 50 aps after the upgrade too, without any problems.

1 Reply 1

Stephen Rodriguez
Cisco Employee
Cisco Employee

With the native VLAN you need one template that enables that.  Then a secondary template that assigns the VLAN mappings.

Give that a try and let us know how it works.

HTH,

Steve

----------------------------------------------------------------------------------------------------------

Please remember to rate helpful posts or to mark the question as answered so that it can be found later.

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: