Commands autonomous AP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-10-2010 05:49 AM - edited 07-03-2021 06:47 PM
Good afternoon,
I get in touch with you to make you the next question ...
You can set any command in the autonomous AP to send SNMP traps to a server from a client asociaicón recorded in the AP and the disassociation of this, if so which command would have to put ... or would be done with some script, as I say would be to send if a client is associated or has failed in the association ...
Thank you very much
Regards
- Labels:
-
Aironet Access Points
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-10-2010 04:10 PM
snmp-serv enable traps authenticate-fail
snmp-serv enable traps deauthenticate
snmp-serv enable traps disassociate
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-10-2010 10:22 PM
Thank you very much for the information, I have been very helpful
Greetings
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-10-2010 10:33 PM
If previous post have answered your question, can you mark it as "Answered"?
