10-25-2007 10:55 PM - edited 07-03-2021 02:50 PM
Hi,
Say I have 2 LAPs on a WLC.
Then I enter,
config auth-list add mic <AP mac>
for one of them.
Does this mean the other LAP,
1) Has it's current LWAPP tunnel disabled
2) Can't establish LWAPP tunnel next time it resets? Must I enter this command for the 2nd LAPs MAC for it's LWAPP tunnel to come up?
If I remove all commands,
config auth-list add mic <AP mac>
from the WLC, will it now allow establishment for all LAPs?
ps. My LAPs only have MIC, not SSC.
Regards, MH
11-01-2007 06:48 AM
Even without this command WLC accepts Cisco LAPs with MICs. But if you add for one AP it is safe to add it for another AP also.
11-01-2007 01:50 PM
Hi,
Not sure what you're trying to say.
I'm looking for a method to make it necessary to explicitly configure the WLC for each LAP added. I was hoping auth-list would be it but some testing showed, as you said that configuring it for 1 AP doesn't stop others LWAPP Joining.
Hence I don't understand the purpose of this command when the "mic" keyword is used.
Regards, MH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide