Wireless

I have received a certificate(pem-file)from Globalsign.Do I have to combine this into a pkcs12 file first, or can I upload the pemfile from GSign right away ?And, if there is something wrong with the certificate, how can I then access the controller ...

Have the requirement to be able to specify the channels that are being used with a 1252. Seem to be able to do this with a US based 1252, but the European version seems to only want to use DFS.Is ther a quick way to disable the DFS function and speci...

Hello, We have several 12xx AP's running fine c1200-k9w7-mx.123-4.JA2 . After upgrade one of the AP's with c1200-k9w7-mx.123-8.JEC2, most of clients cannot connect (even Cisco/Linkys WET's). Another strange observation - with JEC2 CPU usage jump to 9...

Hello!I upgraded 1121 to lightweight with upgrade tool.Now I want it to be joined to 2106.In debug packet I see that 1121 sends discovery request (broadcast, or, after I addedd dns record unicast) to 2106 and 2106 replies. Then there is no join reque...

WLC 4402 connected to 4507 switch.GBIC1 connected to a gigabit port on module 3 of the switch; GBIC 2 connected to module 6. LAG is enabled in the 4402 configuration.I've recently reworked some VLANs, essentially to move workstations and servers off ...

Hi,I have a Cisco 877w router and I'm sure it's not configured correctly by me. If I cable into the router things work fine like the internet and connecting to work etc, however if I wirelessly connect it is never as reliable, it becomes slow etc.Jus...

Does anyone know if the 1500 series which are presently 802.11b/g AP's will be somehow upgradeable to 802.11n AP's. We are very close to putting in a 1.5 square mile mesh system.

Every day at least once and sometimes twice, I have several access points that reboot. They all do it at precisely the same time and it is usually the same AP's - about 8 of them. I have other access points that do not go down.Any ideas? Could this b...

I was told by a wifi tech that the "pipe bomb" antenna [air-ant2506] should be installed upside down when installing inside a building, ie warehouse.When I go to the hardware installation page for the antenna, Cisco makes no statement regarding this....

Hi all, I have a setup whereas I have multiple workgroup bridges with a small switch connected to the ap with 3 pc's on each, these wgb's then associate to an access point. It seems that the connection does not stay alive between them unless we ping ...

Hi, can I make a wireless bridge between a 2142 AP and a 1131 AP?

Current set up is:1 - 4402 - 50ap WLAN Controller with code 4.2.130.01 - 2125- 25ap WLAN controller with code 5.2.15735 - AP1010 access points17 - 1100 series access pointsI've told each access point which controller is its primary controller but aft...

Hi,I have an issue where my new Ap's out of the box in that they are registering with the master controller, upgrading the Lwapp software then rebooting and going through the same upgrade process again and again.Constantly upgrading!!Other AP's that ...