Configuration AP 702i capwap with controller 5508

[NejehAflouk5529]

hi,

i would   to control a capwap 702i with controller 5508, they are located in tow different network.

the ap has join the controller  but when i enable the wlan, no wlan appears.

i'm using flex-connect technology

thank your for event helps.

[Sandeep Choudhary · Accepted solution]

check any AP group are configured on WLC!! if yes then you nee dto add WLAN in the group.

WLAN > Advanced > AP Groups

Regards

Dont forget to rate helpful posts