- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-27-2020 09:39 PM - edited 07-05-2021 12:56 PM
Hello Experts,
I'm working on a new project in a large factory, the objective at this first moment is basically to copy the current configuration in 5508 and paste it in the new WLC 9800-CL, I'm having problems with wireless interface in the new controller, the current configuration is central switching o WLC 5508 has 5 wireless interfaces
But after two or three days I am unable to configure the wireless interface on the new WLC 9800, the status of the wireless interfaces is UP, howerver Can't reaches default gateway of each interface, the configure Int G2 is TRUNK allowed vlans 4,7,45...
I set the ip route 0.0.0.0 0.0.0.0 10.127.109.1 (gateway int mgt dafault).
anybody can help me confirm the configure Interface G2 in WLC or show me exact configuring the Interface in HYPER-V
Solved! Go to Solution.
- Labels:
-
Catalyst Wireless Controllers
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-27-2020 11:24 PM
https://community.cisco.com/t5/wireless/wlc-config-converter-aireos-ios-xe/td-p/2895495
*** Please rate helpful posts ***
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-27-2020 11:22 PM
Also make sure you follow the 9800-CL guide step by step. If you do, you will be able to setup the basic config and get connectivity.
*** Please rate helpful posts ***
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-27-2020 11:24 PM
https://community.cisco.com/t5/wireless/wlc-config-converter-aireos-ios-xe/td-p/2895495
*** Please rate helpful posts ***
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-28-2020 07:20 AM
Hello Scott,
Thanks for your suggestion, I don't think I explained it correctly.
I'm trying to configure the wireless interfaces on the 9800, similar from the WLC 5508 interfaces.
The interfaces wireless can't reaches default gateway,would you have any suggestions.
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-28-2020 09:09 AM
Now once you get connectivity, then you build the policy and tags like the guide explains step by step.
If you are still having issues, please post some screen shots and or config which makes it easy to understand what you are talking about.
*** Please rate helpful posts ***
