Configuring guest access on 2504 WLC

[roy_hayes]

I'm not sure if this is the right place for this but...

I currently have a 2504 WLC and 3 Aironet 2602i AP's with a private network set up. I need to add guest access for visitors. Is it possible to configure this with the equipment I have currently? If so, how?

Thanks.

[Saurav Lodh]

http://www.cisco.com/c/en/us/td/docs/wireless/technology/guest_access/technical/reference/4-1/GAccess_41.html

[mohanak]

Refer the link :

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-vlan/70937-guest-internal-wlan.html

https://supportforums.cisco.com/discussion/11465516/configuring-guest-access-using-2-lwaps-and-2504-wlc

[George Stefanick]

You can segment a WLAN and a VLAN for guest access. The 2504 can also do a simple splash page. 

[john smith]

Hi Roy,

yeah your existing devices support guess access, and the only things you need to do are, configure a new vlan for guest users,

map that vlan within all the route to wlc and internet.

allow internet on that vlan's ip subnet

configure a dynamic interface using that vlan in the WLC

configure new ssid in controller ...GUEST

map the dynamin interface guest

if you want preshared key security for your guest than configure any PSK key under WLAN--GUEST--layer2 security and hit apply

if you want to configure a web-auth authentication. than you either choose layer2 security or choose none to keep it open for guest users...(no Password)

configure layer3 security as web-auth using this document fom link

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-vlan/70937-guest-internal-wlan.html

HTH

[Moin Ilyas]

https://rscciew.wordpress.com/2014/06/19/wlc-webauth-configuration/