08-06-2012 04:13 AM - edited 07-03-2021 10:29 PM
connecting 6 cisco access points 1 to another by wireless, with a good range, what is the best thing to do?
---
Posted by WebUser Nabil B. Emad from Cisco Support Community App
08-06-2012 04:15 AM
If your talking about repeater mode... No way. Even with mesh, that's too many hops. Repeaters cut the throughput in half from each hop. Even just one repeater you can tell the performance degradation.
Cable each one if possible.
Sent from Cisco Technical Support iPhone App
08-06-2012 01:40 PM
but if it was not possible at all to connect cables, and i want to cover all the site by wireless, what solution do you suggest? thank you
---
Posted by WebUser Nabil B. Emad from Cisco Support Community App
08-06-2012 03:11 PM
and i want to cover all the site by wireless,
Please elaborate further.
NOTE: My doctor has taken away my "I-can-read-your-mind" medication.
08-06-2012 11:40 PM
okay , the situation is: I have a project, for a 4 floors villa, the area of each floor is 300 m^2. I have only 1 DSL connection. Note that, we can't connect any cable. What is the solution for this situation. thank you for your efforts
---
Posted by WebUser Nabil B. Emad from Cisco Support Community App
08-06-2012 11:48 PM
You're almost there.
Explain the floor layout (per floor).
How many floors do you want wireless coverage?
What is the structure and floors made out of? Wood? Concrete? Pre-fab? Steel i-beam? Kryptonite?
What's your budget?
08-07-2012 12:51 AM
Are the AP's connecting back to a controller? how many users do they expect?
"we can't connect any cable" im guessing thats meant to say you cannot run any cable.
so is the first AP connecting directly to the router?
08-07-2012 01:14 AM
hi. The floor layout is concrete. I will put 2 for each floor. budget is around 1500 $.
and scott, the first access point is connected directly to the router with a cable. but after that everything will be by wireless
---
Posted by WebUser Nabil B. Emad from Cisco Support Community App
08-07-2012 03:49 AM
It's not going to work... The only way I would design this is to run cables to each floor, in which they would have to core through each floor. Usually buildings have these vertical risers so you can do this.
Sent from Cisco Technical Support iPad App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide