Since 1550 outdoor APs have been designed to work in harsh environment and have better coverage, we consider to use 1552 APs inside a big construction workshop. Are there any concerns or issues to use 1552 AP indoor? thanks.Michael
Hi,I have Wireless controller 5508 at Main site and Cisco 3600 series access points at remote branch. There is only single WLAN broadcasting at both branch and main site.When clients are connecting to remote site AP, there are getting ip address from...
Hello there,I am trying to configure WPA2 802.1x authentication on my WLC that should use ISE as radius server which is set to authenticate AD users.The issue is that when I try to connect the SSID, it does not forward the authentication request to I...
Hi all,I want to add WAP610N Access point for monitoring in my Prime Infrastructure but i didnt find any option of SNMP in WAP610N accesspoint ...i want to know whether there is any way to add these accesspoint to PI.
I just received three AP1262's from Cisco, to replaced my broken AP1262's which were under the limited life time warranty. I hooked them up to my network and they are receiving DHCP addresses but the AP's are not connecting to the controller(s). I ha...
I have a need to link 2 offices that are physically separated by a 3rd office (1 physical building w/ 3 adjoining offices) in the middle. The walls between the offices are plaster. I was wondering if the 2 access points above, either with internal ...
Hi, I 'm looking for a billing solution that can be integrated with WLC 5508; the requirement is to bill internet service for users conecting by wireless network.I've been searching in cisco´s portal but I couldn´t find any option. Does any of you k...
I am experiencing random disconnects during an Airplay session to AirServer. Airserver disappears from the screen and Airplay session is gone. Here is the details of my setup:WLC 5508 7.5.102.01142n APsAirServer (1.9.4) installed on wired PCs.Wireles...
I have a centrally located wlc and access points spread over several "remote" locations.Is it in anyway possible to have an AP act like a credentials cache, at least for little while for existing wireless connections, until the wlc is back??In this c...
When I log into Prime I have access to basically everything. Can I narrow it down for certain user accounts? E.G If I want a user to only have access over a certain AP group or a specific AP?
Hi All,I have a project with Cisco 3600 access points and 5760 controller. One part of the project is a small campus. Unfortunately there are no ethernet cables laid, only electricity. Here´s a sketch:The site length of the campus is about 70 metres....
Hi all,we have successfully implemented Office Extend functionality on 2500 series controller and AIR-OEAP602 access points. We like it very much and my question is: Is Cisco planning to develop software for OEAP600 Series access points? I.e. what ab...
Dear Cisco Team,I am planning to procure one AIR-CT2504 Controller and five AIR-OEAP602I-C-K9 Access Points.I will be physically connecting an Ethernet Cable between Controller and one AP (which will act as a bridging device) and need the other AP's ...
I heard that if you get SmartNET on Cisco WLC or 3850 switch, then APs are also covered under them.Is this true?Rogeliorogelio @ rnd media . com
Is there any way to prioritize traffic from wireless client (laptop in my case) to AP …. if i explain the issue in a broad way there is no congestion going on in wired network. When multiple users connect to real presence and all share the same AP. t...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 08-10-2026 11:32 AM | ||
| 08-06-2026 09:29 PM | ||
| 08-05-2026 05:58 AM | ||
| 07-15-2026 08:23 AM | ||
| 06-12-2026 07:30 AM |
