cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1024
Views
0
Helpful
4
Replies

Continous ARP request every 8 sec

abhi3011
Community Member

We are using Meraki router for connecting the wifi enabled lock. We observe continous ARP request from Meraki router every 8 sec which is obstructing the wifi chip to go into sleep. I wanted to check is there any configuration that can help me disable this continous ARP request every 8 sec.image.pngWireshark capture of the issue

4 Replies 4

aleabrahao
Meraki Community All-Star
Meraki Community All-Star

What is the model of your Meraki device? I've never heard of or seen anything similar.

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

Raphael_L
Meraki Community All-Star
Meraki Community All-Star

I took thousands of pcaps on MX and they all behave like that and even from old to recent firmware including MX 15.44 , 16.16 , 17.X , 18.107 , 19.1.7 , 19.1.12

It's very odd and I never found out why

mwiater
Level 3
Level 3

You might want to open a ticket with Meraki support. As I'm looking at the ARP request, I'm wondering why the MX is sending that packet. ARP requests should only happen for devices thought to be on the same network, I'm having a hard time seeing how the MX could see the who has and the tell addresses on the same net.

mark

Review Cisco Networking for a $25 gift card