In my WiFi network, I have been facing serious problem whole week. Half of people almost did not have connection with wifi. After whole week I came to conclusion that the problem is with channels. I think DCA was not that smooth and still I had interferences.
What I did in Wireless->802.11a/n/ac -> DCA clicked OFF and then manually assigned channels to each AP in 40mhz each AP with 2 channels. After that almost all users said connection is normal. But after some time I checked that channels changed from what I put there. I see that sometimes APs see in Radar Information the channels it is assigned and automatically changes.
How to stop this, and force AP to broadcast only in channels that I put them.
OverviewConfigurationCreate a CSV File With a List of All the APs Joined to the 9800Verifying theCSV File Will Work with the EEM AppletsBreakdown of the Enabling and Disabling EEM AppletsMonitoring the Applet
On the Cisco Catalyst 9800 Series WL...
It’s been a long road for our AireOS wireless controllers. In fact these products have been around Cisco in some form since 2005. As you may have heard, Cisco made the decision to End-of-Sale (EOS) these products last month.
That means that these AireOS ...
Hello Community, I have an issue where APs do not connect to the WLC. Connection is made over VPN. Until yesterday all 3 APfailed with below errors. We change the LAN connection to a cisco router and now one of the AP magically connected to the...
Where to download
Attached files on this post
Alternatively, cloud version (only summaries)
New implementation for the WLC Config Analyzer. it is a new re-write of the application, with clean up and improved checks
Support for IOS...
Cisco Champion Radio · S8|E6: Fastlane+ Optimizes Network and Device Communication
Cisco Fastlane+ is a co-developed solution with Apple that significantly improves the experience of any Wi-Fi 6 capable iPhone or iPad connected to a Cisco Catalyst 9130 A...