DHCP on AP

[mrba_2000]

Hi there,

I've a broadband connection. I'm connecting my AP 1200 series to it. I can get the ip address from the ISP on my AP but the promblem i'm facing now is:

My client wireless card cannot get authentication therefore i can't get any ip address for my client.

My AP setting currently is a factory setting. Do i need to set any ssid,vlan dhcp pool etc etc.

Can someone please guide me how to set this up?

Tks

razz

[scottmac]

The factory default is an SSID of "tsunami," no authentication, no encryption.

Set your clients for an SSID of tsunami and you should be able to connect OK.

BTW: your clients should be rigged to get DHCP addresses from your ISP: the AP won't do DHCP service unless and until you configure it to do so.

Good Luck

Scott

[mrba_2000]

Scott,

Tks for the reply. I've also set my client ssid as "tsunami" still can get any connection.

My question was, how to make my AP to do DHCP service.

Tks