Wireless

HelloI've this scenarioWinXP wifi clients+ Freeradius + Cisco AP1200. Everything works fine but when the option 'WEP rotation' is enabled sometimes XP clients have problems and the authentication fails. Maybe ,during 3-4 hours it works but suddenly a...

Is there any problems or harm that can occur using the 802.11a,b or g technologies around people wearing/using pacemakers or other medical devices like that? Also, is there a website that may contain some of this information?

It's possible to force a 1310 bridge to operate "only" in 802.11b standard, so I can extend cover range on my test site ?Regards,Salvatore

Hi,we 're using br500e (aeronet340) with dish antennas.there is a 2 km between bridges.I think signal levels are ok (60 dbm "in"- 66 dbm "out").But we're having problem with lost packets.we send 2400 packets from router that behind the slave bridge b...

Hey, all. I have a combination of 340s, 350s, 1200s, and 1100s. Is there any way to configure them as gateways? I would like for each access point to have an internal network and for clients to obtain IP addresses from an external DHCP server. Is tha...

hii have a cisco AP1200 series.wireless NIc cards are from Lynksys WMP54GV4 but initially it came with a bad driver and i installed it but that failed cards are not taking the driver but when i installed there was no issue.after that they gave me the...

Hello,I recently upgraded my Cisco 1220 AP to 12.3(2)JA IOS. I also updated by Client (Toshiba Laptop running WinXP SP1) to the latest ACU Client using version 1.5 of the Wizard. The NIC is a 350 Series Cisco PCMCIA card. It is now on Firmware 5.60.0...

Hi,I want to know the range of current consumption of Cisco 350 series WLAN card in transmit mode. The data available online specify only the max. current consumption (450 mA) when it transmits at max power (100 mW), but does not indicate the current...

I have set up PEAP-MSCHAPv2 to work on XP sp1 with Aironet 1220 (latest IOS upgrade from vxworks), MS IAS (on 2000server sp4), Aironet 350 series cards and a varieties of WLAN cards. To migrate from our current static WEP setting, I created 3 vlans. ...

Today we discussed a good design for a voice and data wlan network for approx. 500-800 user and about 500 access points.So far i came up with two different approaches. One using a rather large /16 network and handle the roaming only on l2 or on the o...

Hi all, I have following setup:- Cisco 3600 series router-Remote APG Modem-Local APG Modem-D-Link 8 port switch-Local Cisco Aeronet350 Series-Client Aeronet Access Point-Client local Network.There are 4 others network running with same devices connec...

We are attempting to build a test network, composed of 2 Windows 2003 Std Servers (DC's) and a Windows 2003 Ent Server (DC) which is running IAS Server and is configured as a subordinate Certificate Authority so that we can auto-enroll workstation an...

I have 21 AP1200 running software version 12.2(15)Ja. These have been running fine since Sept 2004 but latelly I receive the following error message on only some of the units:Critical - Memory allocation of 1760 bytes failed from 0xAD218 alignment 4W...