- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-25-2009 12:07 AM - edited 07-03-2021 05:58 PM
Hi there
is it possible to enable SSH for all LAP's on a WLC console (and even on the GUI)? I only know the command "config ap ssh enable <Cisco AP>", is there a hidden command for all LAP's or a global command to enable SSH per default?
Thanks a lot and best regards
Dominic
Solved! Go to Solution.
- Labels:
-
Wireless Security
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-25-2009 12:33 AM
It does not seem to be a way on the CLI/ GUI of WLC for ALL the AP from one time click:
http://www.cisco.com/en/US/docs/wireless/controller/6.0/command/reference/cli60.html#wp8904301
If you have WCS, I think you can run a template to disable it on all the APs, but this does not exists on the CLI / GUI of WLC.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-25-2009 12:33 AM
It does not seem to be a way on the CLI/ GUI of WLC for ALL the AP from one time click:
http://www.cisco.com/en/US/docs/wireless/controller/6.0/command/reference/cli60.html#wp8904301
If you have WCS, I think you can run a template to disable it on all the APs, but this does not exists on the CLI / GUI of WLC.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-25-2009 12:47 AM
Hi lavramov
thanks a lot for your replay, what I expected but not what I wanted ;-)
We will solve it via WCS.
Best regards
Dominic
