cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
846
Views
0
Helpful
1
Replies

Error message LWAPP-3-DISC_INTF_ERR1

hdrodriguez
Level 1
Level 1

I'm getting this error in the log of the WLC. This error showed after a power outage and the switch that WLC was connected to lost its config. It has since been replaced and is up although my wireless network is down for oth data and voice. I'm a newbie so I need a little help with this one. Thanks in advance. Error message is below:

LWAPP-3-DISC_INTF_ERR1: Ignoring discovery request received on non-management interface (2) in L3 LWAPP mode

1 Reply 1

jsivulka
Level 5
Level 5

The above error message means - A discovery request from an AP was ignored because it was received on an invalid interface. Network configuration may be invalid.

Recommended Action - Check network configuration to ensure that packets from the AP are correctly routed.

For more information please click following URL:http://www.cisco.com/en/US/docs/wireless/controller/message/guide/msgs6.html

Review Cisco Networking for a $25 gift card