Getting the following alert in NCS

[Islam Sallaj]

All,

I keep getting the following alert in Cisco NCS anyone have any insight?

CPU Receive Multicast Queue is full on Controller

Thank you in advance.

izzy

[Scott Fella]

Take a look at this post by Saravanan

https://supportforums.cisco.com/message/3651475#3651475

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

[Abhishek Abhishek]

Hello Islam,

You can configure Controller in Multicast Mode-

The NCS provides an option to configure IGMP (Internet Group Management Protocol) snooping and timeout values on the controller.

To configure multicast mode and IGMP snooping for a controller, follow these steps:

Step 1 Choose Configure -Controllers.

Step 2 Click the IP address of the desired controller.

Step 3 From the left sidebar menu, choose System -Multicast.

Step 4 Choose Disable, Unicast, or Multicast from the Ethernet Multicast Support drop-down list.

Step 5 If Multicast is selected, enter the multicast group IP address.

For more information you can refer the link-

http://www.cisco.com/en/US/docs/wireless/ncs/1.1/configuration/guide/ctrlcfg.html