02-10-2011 01:53 PM - edited 07-03-2021 07:48 PM
Can I configure guest access on a H-Reap Ap so that guest traffic is switch locally and not send to the controller? Are there any documents that explain how this can be configured?
02-10-2011 03:01 PM
yes, you can have a webauth ssid that is locally switched. however, initial authentication via http has to still go the wlc.
there is no document that explain webauth + hreap + local switching
create the webauth ssid / try it on a local mode ap if you have one
enable local switching on the ssid under the advanced tab
do the local switching configuration on the ap side from the wlc gui
add any needed vlan to the trunk of the ap interface
it should be done
thanks
Serge
02-10-2011 05:33 PM
Thanks. I will definitely try this
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: