Hi,
We were guided by Cisco Small Business to use Cisco WAP4410N access points for a VLAN capable access point. When they are working, they give good distance, but the problem is we are having to reboot them frequently (weekly if not quicker).
We currently have 8 of these access points installed (this is a church and school). We don't have budget to replace them, but there are still a few areas that don't get coverage. We are planning on adding additional access points but somewhat hesitant about putting in more of the WAP4410N's since they aren't as stable as I would like.
We only have around $1000 to spend to add additional access points. Do you have any recommendations about whether we add additinoal WAP4410N's since we're using them now? If so, do you have any recommendations on getting them to be more stable? We've updated the firmware but not sure what else we can do.
If we should start investing in other hardware, let me know which models you think would be good to go with, and as we have budget we'll start replacing the other WAP4410N's.
Thank you!
--Kent
