10-07-2011 04:28 PM - edited 07-03-2021 08:53 PM
I have a WLC 2016 and a LAP1131AG plugged in to one of the POE ports. On firmware 7.0.116 I have no problems powering the AP.
On 6.0.222 I get an error:
HIGH_POWER_CLASSIC_NOT_CONFIGURED AIR-WLC2106-K9
and the usual radios off.
How do I get the 2106 to power this correctly, or have the thresholds of low power perhaps changed?
Simon
10-07-2011 04:36 PM
Go to "All APs", click on the AP of your choice, go to the "Advanced" tab and on the right-hand section under PoE.
10-07-2011 04:45 PM
Do I select "Pre-stadard state"? Funny how this worked on 7.x...
Simon
10-07-2011 05:00 PM
Yes. Select "Pre-Standard". This may reboot the AP and you'll know it works because radios will go up.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide