how can the clients connect to AP and secure by VPN 3005?

[zhuangwenbo]

we want to deploy the AP in office, and hope the clients could be secured by a VPN 3005. so we need to connect the AP to VPN 3005. does anybody know how can i configure the AP and the VPN 3005? and how can the clients get the initial IP address to communicate with the VPN 3005 to setup the secure tunnel?

[a.kiprawih]

Hi,

Pls follow the configuration guide in the url stated below - how to configure secure wireless LAN connectivity via IPSec VPN through VPN 3000 Concentrator.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2284/products_configuration_example09186a008014a37c.shtml

In the WLAN environment, the wireless client first associates itself to a wireless Access Point (AP). Based on the IP address range it receives from the wireless connection, the VPN Client installed on the wireless automatically launches a VPN connection request to the corresponding VPN Concentrator on site. The IPSec VPN connection is then used the secure the wireless 802.11x traffic. Without the successful establishment of the Cisco VPN connection, the wireless clients have no access to the network resources.

Hope this guide relevant to your network environment.

Rgds,

AK

[zhuangwenbo]

Thank you very much! I'm looking into it.

[a.kiprawih]

Pls rate the post if it helps.

Rgds,

AK