09-25-2013 07:56 AM - edited 07-04-2021 12:56 AM
How do you show the controllers configured on an AP? When I read through the docs it say to use the show capwap ip config.
You can use the show capwap ip config command in enable mode to view the CAPWAP configuration present on the LAP.
Here is an example:
AP1240#show capwap ip config LWAPP Static IP Configuration IP Address 10.77.244.199 IP netmask 255.255.255.224 Default Gateway 10.77.244.220 Primary Controller 172.16.1.50
http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a00808e2d27.shtml
When I run it I get no output. I am guessing because the AP is DHCP
3602-E#sh capwap ip config
LWAPP Static IP Configuration
I am not having any luck finding this data anywhere else.
3602-E#more flash:private-config
%Error opening flash:private-config (Permission denied)
thanks
CCNP - Wireless
CWNA and CWAP
Solved! Go to Solution.
09-25-2013 08:26 AM
you can try show capwap client config
you are looking for the "mwar" lines
HTH,
Steve
------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
09-25-2013 08:02 AM
try: show capwap client rcb
Thanks,
Scott
Help out other by using the rating system and marking answered questions as "Answered"
09-25-2013 08:26 AM
you can try show capwap client config
you are looking for the "mwar" lines
HTH,
Steve
------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
09-25-2013 12:55 PM
show capwap client config shows me all the controllers configured. thanks!
CCNP - Wireless
CWNA and CWAP
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide