12-21-2017 01:27 AM - edited 07-05-2021 08:00 AM
hi everyone
i have WLC 2504 with 15 AP 1142 , firstly how i can control a broadcast of 2.4 or 5 ?
and my question here if i want to transmit 5ghz (because it better than 2.4 in rate)
but its cover small space than 2.4 so i want to put 5 ghz as primary signal and if the client go far away and go out of the 5 ghz range still in the network with 2.4ghz is that possible?
another question plz
is there any polices controlled the join to the signal ? when the client join with 5 GHZ and when he join with 2.4 ?
how i can controlled that ?
Solved! Go to Solution.
12-21-2017 02:57 AM
@Mohanadz wrote:
so how i can broadcast just 5Ghz signal from controller ?
Look under the settings for the SSID and look at "Radio Policy" drop-down menu.
12-21-2017 02:18 AM
12-21-2017 02:42 AM
12-21-2017 02:50 AM
@Mohanadz wrote:
when the client join with 5 GHZ and when he join with 2.4 ?
how i can controlled that ?
That will depend on the wireless client. The most recent wireless NIC drivers from Intel dictate that 5.0 Ghz takes priority and, in most common circumstances, operate on 2.4 Ghz if 5.0 Ghz RSSI is bad. But, when operating in 2.4 Ghz, if the SNR is low, for example, then switch back to 5.0 Ghz.
These are just examples. We don't "write" the codes to the wireless NICs.
@Mohanadz wrote:
1-how i can recognition 5 or 2.4 radio is broadcast now ?
You look at the controller and pull up details of each wireless clients.
12-21-2017 02:55 AM
12-21-2017 02:57 AM
@Mohanadz wrote:
so how i can broadcast just 5Ghz signal from controller ?
Look under the settings for the SSID and look at "Radio Policy" drop-down menu.
12-21-2017 07:16 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide