Hello.
- Topology -
WLC - L3SW - RAP - MAP - L2 - PC
RAP - MAP Check.
Checking the signal quality the 'Show mesh ap tree' command.
Check the SNR value.
I have a question among them.
1.Chan Util
- When there is no traffic, it is 10%, and when there is a lot, it is more than 70%.
In this case, PC users feel disconnected.
- How is this item calculated?
2.
RAP <-> 4 MAP : in this configuration, only one MAP has a lot of traffic, and other MAPs are affected in the sector even if there is no traffic?
ex)
(Cisco Controller) >show mesh ap tree
========================================================================
AP Name [Hop Ctr,Link SNR,BG Name,Channel,Pref Parent,Chan Util,Clients]
========================================================================
[Sector 1]
----------
_RAP_1[0,0,,(149,153),None,51%,0]
|-_MAP_11[1,26,,(149,153),None,58%,0]
|-_MAP_12[1,32,,(149,153),None,54%,0]
|-_MAP_13[1,24,,(149,153),None,54%,0]
|-_MAP_14[1,34,,(149,153),None,57%,0]
[Sector 2]
----------
_RAP_2[0,0,,(149,153),None,0%,0]
[Sector 3]
----------
_RAP_3[0,0,,(149,153),None,53%,0]
