Out of the box, the AP comes with a default SSID "tsunami", channel set to LCF and power set to full 100 mw/30mw (CCK/OFDM), ip address of 10.0.0.1.
These parameters can be changed via web interface or CLI.
Configuration of these via web interface is very straighforward. To get started, once you access the AP via web interface, click the Express Setup and Express Security to setup minimal settings to make the AP operational.
I prefer CLI to web interface.
conf t
int do 0
ssid
power local ofdm
channel <2412, 2437, 2462>
power local cck
no ssid tsunami
username admin password
no username Cisco
hostname
int bvi 1
ip address
ip default-gateway
HTH
Additionally this link should help!
http://www.cisco.com/en/US/products/hw/wireless/ps430/products_installation_and_configuration_guide_chapter09186a0080147d6f.html
Sankar Nair
UC Solutions Architect
Pacific Northwest | CDW
CCIE Collaboration #17135 Emeritus
