How to configure in Autonomous Mode in two Aironet CAPs

[german_molina1]

Hello people!

I´m new in this kind of CLI configurations because I´m not goint to use WLC.

I´ve attached the desire architecture. The APs that i´m going to use are Aironet 1552S. Please if any one of you knows the command lines to configure the APs and can share it with me, it would be awesome! Two days left until the project starts! I appreciate your knowledge and expertise. Thanks!!!

Andres 

[Sandeep Choudhary]

Here are guides posts about autonomous ap configs:

https://www.cisco.com/c/en/us/support/docs/interfaces-modules/security-modules-routers-switches/116586-config-ap-00.html#anc8

https://rscciew.wordpress.com/2014/05/24/single-ssid-configuration-on-autonomous-ap/

https://nickjvturner.com/2017/01/20/autonomous-cisco-ap-multiple-ssids/

Regards

Dont forget to rate helpful posts