How to configure port channel In WLC 8540

[rohitbhanu09]

Hi,

We are looking how to configure port channel in wlc 8540. We have two datacenter and each data center we have two Nexus 7k and one wlc each datcenter. And we want to connect one wlc to both nexus (one datacenter) so we are looking for any port channel configuration in wlc to support port channel configuration.

[pieterh]

the controller has no etherchannel
it uses somtething similar called LAG

search in this document for LAG

basically you need to enable LAG on the switchinterfaces facing the controller.
then you can create a dynamic interface in the conttroller and select primary en backup port.
As far as i know it is no load-balancing, it's only failover.